mooserov
11-25-2008, 11:49 PM
Hello,
I've had my MBC installed for a while, set at 24psi. when I install the Z-chip and start the car, it runs for a few seconds and dies. Remove the chip and plug the sensor back stock, runs fine. Has anyone seen this? I am on the white wire with the red stripe.
Gary
I've had my MBC installed for a while, set at 24psi. when I install the Z-chip and start the car, it runs for a few seconds and dies. Remove the chip and plug the sensor back stock, runs fine. Has anyone seen this? I am on the white wire with the red stripe.
Gary